一、product features:

S506 is a single component, quick drying tasteless environmental protection anti-corrosion paint, the only domestic organic solvent-free environmental protection paint. This product is simple: suitable for brushing, spraying, dipping three process, fast curing speed, good adhesion to a variety of circuit board. Has good high and low temperature performance; a layer of transparent protective film after curing, excellent insulation, moisture-proof, anti leakage, shockproof, dustproof, corrosion resistance, anti-aging, corona resistant performance. Three properties to the national military standard (GJB150.10-86, 150.11-86, 150.9-86, 150.3-86, 150.5-86)

二、typical application:

Widely used in various electronic components, circuit boards, IC chip has been assembled, protect the thread board from various chemicals, salt spray, humidity, electrical insulation, dust, vibration and high temperature and other adverse environmental impact.

三、the technical parameters before and after curing:

The mechanical properties and electrical properties of the data are in 25 ℃, relative humidity 55% curing for 72 hours after the test.

四、the use of technology:

1．prior to coating, must first be coated objects surface water and oil in addition to the net

2．of the best operation: direct dispensing or brush, such as sleep concentration, can be added with deionized water or 1 ethanol: 0.3-1

3.spraying process: Special thinner,

A. circuit board protection available to our Dilution, addition amount of diluent, adhesive of low viscosity, coating thickness; conversely, glue with high viscosity, coating thickness thickness. Diluent amount recommended for 2: 1.

B. Will be diluted glue into the spray bottle, spray.

C. spraying using thinner after cleaning spray.

4. dip coating process:

   A. and 3.A.

   B. will be diluted glue into the immersion barrel, used for dipping, circuit board or component into the speed is not too fast, to avoid bubbles. Dry time table for 10-15 minutes at room temperature.

   C. dipping again after use, if the surface crust, the epidermis was removed, can continue to use.

5.out of the brush, spray gun should use thinner cleaning in a timely manner, to prepare for the next use. Construction attention to ventilation, solvent and paint in the volatile, ensure safety.

6.this product is single component packaging, used by the moisture content and volatile in the air curing contact. The moisture content of the air is higher, drying and curing faster; the higher the temperature (not more than 100 ℃), paint curing quickly.

7. the construction ventilation should be maintained. During the operation, should avoid to wear easy generation is electrostatic overalls.

五、the matters needing attention:

1．out of the bottle of glue, should be wiped clean opening glue, tighten the cap, sealing the shade preserved. Again, if sealed, a little crust, its removal can, does not affect the normal use.

2. do not glue has poured out to fall back to the original packaging, in order to avoid the pollution of glue.

3．keep away from children

4. this product contains modified resin, if inadvertently splashed into eyes, please rinse immediately with plenty of water, such as there are still unwell should be checked to the hospital.

六、storage and transportation:

store in a cool, dry and ventilated place, storage of the products for 6 months (25 ℃), according to general chemical transportation.

七、packaging specifications: 5 liters / barrel, 20 liters / barrel.